Skip to Main Content »

Accessories

8 Item(s)

per page
Set Descending Direction
  1. AppFire

    AppFire

    AppFire It's now here the pellet stove controlled with an App directly on your smartphone.
    • App Control, both at home and at a remote location
    • Wi-Fi connection with your home router
    • Simoultaneous connection to many smartphones
    • Free AppFire for Android e iOS systems
    Easy and intuitive to use: the App can control the pellet stove directly from
  2. WiFire

    WiFire

    WiFire is the Wi-Fi interface module that the user connects to the electronic board of the stove for a complete monitoring of the stove from the App, both at home and from a remote location.   Features
    • Accessory for AppFire
    • Standard Wi-Fi connection.
    It includes:
    • 1 WiFire module1 stove serial cable1 power supply 230 V type wall adapter via...
  3. Lambda Controller

    Lambda Controller

    The absolute accuracy for a perfect combustion
    • “Active” management of the combustion
    • Regardless of the biomass type
    • Efficiency improvement and consumption reduction
    • Lowering of combustion residues
    • Self-test probe / alarms
    • Compatible with narrow/wide band probes
    • Compatible with all HOTTOH controllers...
  4. DIFFERENTIAL VACUUM METER

    DIFFERENTIAL VACUUM METER

    The vacuum meter is an essential device for switching off the feed screw drive and halting the supply of fuel in the event of a pressure drop or flue blockage (depending on where it is installed). The device can be supplied pre-calibrated for:
    • 20/10 Pa
    • 50/30 Pa
    • Other values on request (within a range from 10 to 400 Pa)
    Main
  5. WATER PRESSURE TRANSDUCER

    WATER PRESSURE TRANSDUCER

    Transmits the pressure of the water circuit in which it is installed to the basic controller or expansion unit 2 (depending on system configuration).
    • Measurement range: 0 to 4 bar
    • Measurement precision: ± 2%
    • Maximum permitted overload: 8 bar
    • Power supply: 5 Vdc (from basic controller)
    • Fitting: G 3/8"
    Connection cable available
  6. RECHARGING BASE for hand-held radio terminal

    RECHARGING BASE for hand-held radio terminal

    Holds the hand-held radio terminal when not in use. Connected to a mains power socket (Europe/USA standard, without voltage selection). Recharges the battery of the hand-held radio terminal. Recharge time depends on level of battery charge. Recharge current is accurately metered to allow the terminal to remain permanently in the base without degrading the battery. Depending on system
  7. RX/TX INTERFACE MODULE

    RX/TX INTERFACE MODULE

    This module is installed in the corresponding connector on the basic controller, and acts as an interface between the basic controller and the hand-held radio terminal. Must be installed outside the stove on its back panel. Includes multipolar connection cable (L = 35 cm)
  8. GSM REMOTE CONTROL MODULE

    GSM REMOTE CONTROL MODULE

    Connects to the basic controller via a dedicated connector. Allows the system to be controlled remotely by means of simple SMS messages that can be sent from any device. Compatible with all kinds of mobile phone and all mobile telecom service providers. Requires a standard SIM (top-up or contract). Can be installed on the back panel of the stove/boiler or wall mounted. Includes: Wall adapter

8 Item(s)

per page
Set Descending Direction